The question in the title of this article is, of course, almost nonsensical. Given an opportunity to choose between definitions or controversy, professionals in the marine industry would chose definitions over controversy. Examination of many ship repair, conversion and construction specifications leads to the observation that, perhaps inadvertently, controversy has been selected instead. Here are some examples and lessons learned.
Electronically Transmitted Drawings: A shipyard commenced construction of large vessel. It also arranged with the vessel purchaser’s staff to receive electronically the entire set of contract drawings. From these drawings, the shipyard would proceed to develop the design details as needed for construction. The drawings were received electronically, but not as a CAD files, which could be utilized by the shipyard. The drawings were PDF files, which are essentially just ‘pictures’, not files that can be altered. Those ‘electronic’ files were no more useful than if the shipyard had received paper printed drawings. Lesson learned: Define ‘electronic’ with greater precision so there is no misunderstanding about the form that the information will be transmitted and received.
Renew: Due to grounding in a channel, the rudder of a ship was damaged. The repair specification called for the shipyard to “renew” the rudder. What is meant by “renew”? The ship owner’s representative rejected the shipyard’s repair of the rudder, stating that “renew” meant to build a new one. In contrast, the shipyard said renew meant to make the old one like new by repairing it, making new only the damaged portions. Perhaps the ship owner’s idea would have been better expressed by stating that the shipyard was to “replace the rudder with one of all new materials.”
Pressure Test of Hydraulic Piping: The specifications called for a pressure test to confirm the integrity of joints in a hydraulic piping system. However, that specification did not define the nature and type of test. A dispute arose about what medium to use to create the pressure: air, water or hydraulic oil. A naïve owner’s representative argued that hydraulic oil should have been used. The shipyard pointed out that if there was any leak, it would be detected by seeing oil spray onto nearby fittings and equipment (hopefully without a resultant fire). If water was used for pressure tests, contamination of the subsequently-used hydraulic oil may result. Perhaps a combination of air test (with soap solution on the exterior of joints) followed by an oil pressure test may be the preferred solution. Other possibilities exist, too. More to the point, a specification requiring tests should state the testing mechanism. Otherwise it can be expected that a contractor will select the least-cost solution for the test.
Generator Load Test: A specification called for the replacement of a ships service diesel generator, with subsequent testing to confirm proper operation and controls. The means and extent of testing were not defined. After installation, the shipyard sought to test the SSDG using ship’s equipment for the electrical load. The vessel’s chief engineer as well as the port engineer would not allow that; they expected that the shipyard would use a test load bank instead. The shipyard pointed out that because the specification did not mention a load bank, the rental of one was not included in the bid. This problem involving both cost and delay would have been avoidable if the means of the test was defined. Again, this was an opportunity for the ship owner to appreciate that the contractor would select a least-cost solution unless the specification clearly required otherwise.
To read more, see Part 2 of this article.